Search:

1. Enter Keyword(s)

in 

Categories

Fault Wizard II Primary Cable Fault Locator

Fault Wizard II  “Thumper” Primary Cable Fault Locating System
Fault Wizard is a portable, user-friendly system for URD primary cable fault location. Using arc-reflection technology it includes Hi-Pot (10kV), HV TDR and cycle (thumper) modes for pinpointing faults in underground primary and mining main feeder and trailing cables. The display shows the distance in feet or meters to the fault location.

The Fault Wizard will shoot through transformers and will locate faults up to 10,000 feet. Therefore, the Fault Wizard is great for faulted-cable section isolation. The impulse voltage is variable, which allows low-voltage pulsing and minimum damage to cables. The system has a cycle mode for use in pinpointing the fault with a headset listening device. However, the Fault Wizard has sufficient power to often be felt and heard above ground. 

In cycle mode, the Fault Wizard's batteries will last over 1 hour (full battery charge) and deliver a 350 J pulse (10 kV charge voltage) every 6 seconds. The cycle rate is faster at lower voltage settings. The system also has a hi-pot mode (DC output variable from 0 to 10 kV) for checking the breakdown voltage of the fault in an isolated section of cable or the integrity of an isolated section of cable (to insure the fault is in that section of cable before re-energizing).

The battery voltage will flash on the display when the batteries are low and need recharged. Battery recharging is accomplished through the 120 VAC socket located on the panel. Changing the velocity of propagation setting is easily accomplished by up and down buttons located on the panel. The Fault Wizard's internal system is environmentally shielded and housed in a very durable rotationally-molded polyethylene case. Three handles are attached to the case for convenient carrying by one or two people.

Select Connector Option Below: Alligator Clip Connectors or wired for Mechanical Connectors - Sold seperately